What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 19.06.2025 06:16

2024–10–16 [ OO OLAOYE OYEBODE ]
a photo is worth a thousand words.
The bolt then partially travels down the line to your home.
The other is “what does a “fuse” do?”
I post the exact comment here.
the problem then depends on "how fast does the fuse operate?".
He then describes Rainy Season and Lightning.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Can you summarize season 1 of "The Acolyte"?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
But it can get overloaded, and no longer works.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is 'the assistant's answer'
The MOV will conduct when the voltage exceeds 50% of line voltage.
At least they know the answer if they wanted it.
What can I do to deal with disrespectful children?
A circuit breaker is similar, but is resettable.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
nine
How do you stop your balls from sweating?
He then describes the function of a fuse.
but I think this circuit , shows a few more pieces.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Here is a simplified AC power diagram.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Why do so many people find Kakashi's character so appealing and inspirational?
There are two important concepts here.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
What do feminists mean when they say they want to ‘normalize’ menstruation and its discussion?
These devices are installed between the “hot” and “neutral” and protective ground.
This one hit behind the barn.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What is your review of X-Men '97 season 1?
eight
This device then solves the entire problem.
In schematic diagrams this is the symbol for a fuse:
What’s a mistake most guys make when trying to get a girlfriend?
For this case there are devices called Metal oxide varistors (MOV).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
He then asserts :
An AC voltage/ current source, and an ac inductive load.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
so, what happens?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
One is “what exactly is in a ‘surge protector’ ? ”
Trump Military Parade: Darcy cartoon - Cleveland.com
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
First Sentence:
what exactly is a ‘surge’ protector?
Brad Pitt and Tim Cook surprise fans at Apple Fifth Avenue ahead of ‘F1 The Movie’ release - 9to5Mac
What does a fuse do?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
At one ohm, the resistor has a maximum of 1 watt power.
but this device (an Inductor) … impedes the rapid changes in the current.
This is where the MOV conducts again, and dissipated the energy.
Upvotes:
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
There are three different concepts here that are getting confused.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Edit 2024–10.
One
It also is a device that limits the change in current flow.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
A fuse is a non-resetable over current circuit protector.
[old diagram got deleted by accident]
2024–10–14 [Omar Gharbi Omar Gharbi ]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Barnstars:
The third is lightning and “how it gets conducted into a home.”
(Dc diagram shown, AC is similar).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–10[John johnson John Johnson ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
It seems Mohan does not understand the difference between a comment and an Answer.
What is lightning?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
[image of Common-mode choke]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Now when you have a certain ac resistance, then a current flows in a loop.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These are simplified answers to the original question, and does not change anything I wrote above.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.